mannwranglers
10-31-2011, 04:45 PM
A little help,
I cannot figure out why my CW is doing this....I've tightened the roller bearings on the Z Truck, cleaned the rollers on the head, went under the machine and tightened all 4 phillip head screws, tightened all 4 bolts to the rails on the head..... And still it starts to deeper after about 6 to 10 minutes of carving, causing bad carving lines on the board.
If anyone has had this problem, please let me know.... I've alot of clock orders for this coming Christmas to do..... Any advice will be greatly appreciated!!
Thanks,
George,
SC
I cannot figure out why my CW is doing this....I've tightened the roller bearings on the Z Truck, cleaned the rollers on the head, went under the machine and tightened all 4 phillip head screws, tightened all 4 bolts to the rails on the head..... And still it starts to deeper after about 6 to 10 minutes of carving, causing bad carving lines on the board.
If anyone has had this problem, please let me know.... I've alot of clock orders for this coming Christmas to do..... Any advice will be greatly appreciated!!
Thanks,
George,
SC