Bill Pratt
10-30-2011, 01:23 PM
I write in my practice quiz concerning Tabs & Place Tabs in the "Carving" menue.
i frequently use the cut out feature of the CW machine to finish off the carving. This has been successful in even very complicated shapes. Rececently, however, I have run into a problem when attempting to cut out either a square or oblong feature.
When trying to cut out out a square or oblong the cut out has very small tabs and the entire top (keypad) side leaves over th 1/8 inch solid tab for the entire lenght of the feature. Because this is almost always the direction of the grain, it does not break out properly.
I have tried to use "Place Tabs" fron the main menue and from the "Carving" menue to no avail. There arte no instructions for this feature in the written manual (that I can find) and in the electronic version there is a zero response using the word search!
Help.
i frequently use the cut out feature of the CW machine to finish off the carving. This has been successful in even very complicated shapes. Rececently, however, I have run into a problem when attempting to cut out either a square or oblong feature.
When trying to cut out out a square or oblong the cut out has very small tabs and the entire top (keypad) side leaves over th 1/8 inch solid tab for the entire lenght of the feature. Because this is almost always the direction of the grain, it does not break out properly.
I have tried to use "Place Tabs" fron the main menue and from the "Carving" menue to no avail. There arte no instructions for this feature in the written manual (that I can find) and in the electronic version there is a zero response using the word search!
Help.