View Full Version : Reversed Carvings
Mark Fessel
01-19-2007, 10:48 AM
I acquired a CompuCarve last week. So far I like the results; am waiting for other bits for further testing. I only have one problem: The carvings come out oriented toward the Sliding Guide Plate instead of the Squaring Plate. Is this normal, or have I toggled a flip function inadvertently?
Aaron B
01-19-2007, 10:54 AM
Nope, that the way it should look. In Designer the top of the board is the part that goes against the squaring plate.
Mark Fessel
01-19-2007, 12:40 PM
Thanks. You put my mind at ease.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.