PDA

View Full Version : Cut path not highlighted



Aaron B
01-19-2007, 08:09 AM
never mind, figured it out. Dang I hate it when that happens.

BobHill
01-19-2007, 09:01 AM
Me too, Aaron <g>.

Digitalwoodshop
01-19-2007, 10:43 PM
WE.... yes WE are going to make that same mistake.... Please tell.... WE learn from others.

AL

Aaron B
01-20-2007, 05:49 AM
I was drawing a square with rounded corners using the the arc command and line command.

I started with the arc, picked two points and left it highlighted and then drew a line and then another arc and so on until I made my square. Thats the only way I know how to make it "one" item, as when its clicked on the whole thing highlights.

After I cut done the cut path command was not highlighted and I couldn't figure out why, in the end it was because I didn't have the square closed. I thought I did but two endpoints must of been off just a little, after I fixed it cut path became available.