PDA

View Full Version : spiral pattern



mwhatch
10-18-2011, 12:31 PM
1/2 inch spiral.

CarverJerry
10-18-2011, 02:02 PM
So would this make a thread design on a dowel?

CJ

atauer
10-18-2011, 02:03 PM
Theoretically, yes it would. There are a lot of variables to consider, but as long as the design is perfect, it should make a thread design on a dowel. I have a feeling that there is going to be a lot of people testing different methods to this.

edzbaker
10-18-2011, 08:21 PM
Jerry, I posted a picture and explanation of a threaded piece here: http://forum.carvewright.com/showthread.php?19144-The-cat-is-out-of-the-bag..-Round-Carvings-are-possible-with-the-Carvewright./page26 I guess I had forgotten where this thread was..

Ed

CarverJerry
10-19-2011, 08:48 AM
Yeah, I seen that Ed, thanks. Now if only we could figure a way to carve a nut to fit. It was just a thought any ways.

CJ