PDA

View Full Version : Cross Cutting?



mannwranglers
10-15-2011, 12:10 AM
I'm having trouble with the cross cutting..... I put in a board and needed to cross cut at 37 inches and it measured fine but when it asked me to put in the board thickness and I put in .70 it went back to 0!

Did somthing happen to the software or do I need to do something different?
I finally played with it enough to get it to cross cut but I had to put in .650 on the board thickness.... I've never had to do this before!!!

Can anyone tell or explain to me how to change it back to what it was??

Thanks
George

b.sumner47
10-15-2011, 03:13 PM
You might try in thousands like 0.750. The way you did your measurment .70 will no work with the CarveWright program.You must enter this way, under an inch start 0.0000 , over one inch would be 1.000 and so on. Capt Barry