PDA

View Full Version : Routed edges



cwm
10-04-2011, 07:00 PM
Hi folks,

Quick question, I just watched video tutorial where they said to rout the board edge before carving. Is this correct ?

Thanks

Chris

lawrence
10-04-2011, 07:03 PM
which tutorial? I tend to rout/etc after I carve

Lawrence

Old Salt
10-04-2011, 07:07 PM
You need a sharp edge to measure the end of the board I like to rout after and if you leave the 3.5 " you can cut it off first.

cwm
10-04-2011, 07:15 PM
which tutorial? I tend to rout/etc after I carve

Lawrence

It wasn't on this site. It make sense not to rout an edge before carving, the board surface dimensions will be changed after routing.