View Full Version : Routed edges
Hi folks,
Quick question, I just watched video tutorial where they said to rout the board edge before carving. Is this correct ?
Thanks
Chris
lawrence
10-04-2011, 07:03 PM
which tutorial? I tend to rout/etc after I carve
Lawrence
Old Salt
10-04-2011, 07:07 PM
You need a sharp edge to measure the end of the board I like to rout after and if you leave the 3.5 " you can cut it off first.
which tutorial? I tend to rout/etc after I carve
Lawrence
It wasn't on this site. It make sense not to rout an edge before carving, the board surface dimensions will be changed after routing.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.