View Full Version : Edge routing
ChipperBob
01-18-2007, 03:43 PM
Newbe here. Still confused about edge routing. Assume I cut the board corners at 45°. I now have eight new edges and four free (loose) pieces. How do I edge rout the remaining eight sided board?
cmorlier
01-18-2007, 03:51 PM
The built-in routing function only supports rectangular boards.
If you design a octagon is the Designer, then you can put a rout on the octagonal path.
BobHill
01-18-2007, 03:51 PM
You do your routing totally INSIDE the work wood piece, so the wood has to be quite a bit larger, not just barely to cover the widest sides.
Bob
Dan-Woodman
01-18-2007, 05:22 PM
Design your project ,rout it , then cut it out.
Look at my last post under "HI" in software. It shows an example of routing on the board and then you can cut it out .
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.