myshop1044
09-27-2011, 10:19 AM
I replaced the "Y" motor asem the other day, I removed the "Z" truck cleaned the bearings and replaced it afterwards.
I did a couple of 20 min carves using the carving bit, 1/16 strainght cut bits and I felt heat at the CT head as I was changing the bits out.
There was no heat on the flex shaft at all. I did another test carve today about 6 min and the heat was there again.
Any Ideas as to problem. I did not have a heat problem before I remove the truck for cleaning.
Perry
Myshop
I did a couple of 20 min carves using the carving bit, 1/16 strainght cut bits and I felt heat at the CT head as I was changing the bits out.
There was no heat on the flex shaft at all. I did another test carve today about 6 min and the heat was there again.
Any Ideas as to problem. I did not have a heat problem before I remove the truck for cleaning.
Perry
Myshop