PDA

View Full Version : Help with textures.



woodgeek
09-27-2011, 06:45 AM
Anyone know how to add a new texture to the designer software?

AskBud
09-27-2011, 06:50 AM
Anyone know how to add a new texture to the designer software?
Here is a old response on the subject.
http://forum.carvewright.com/showthread.php?4593-import-textures&p=32096#post32096

Once it's placed in designer, you may use the "Clip-carving" option to limit the scope of this pattern as needed.
My "Download" link, below, has a lesson titled "Clipping a Carving" should you need to review the "Clip" process.


Then again, perhaps the Tip & Trick from November of 2007 (Issue #2, titled "Group & Merge Features") will give you the concept to allow your new texture to appear as you wish. See this link: http://www.carvewright.com/downloads/tips/CarveWright_Tips_and_Tricks_Nov07.pdf
AskBud

bjbethke
09-28-2011, 03:06 AM
Anyone know how to add a new texture to the designer software?

Welcome to to the forum, it looks like this is your first post. I am not truly sure what you are asking for, but if you are asking to chance the back ground in designer, I take photos of the wood I cut on my Saw Mill. you need to make them in the JPEG format as a 512x512 size and put them in the "wood1" folder in your hard drive in the CarveWright program.