Aaron B
01-18-2007, 12:38 PM
If you have a big board and are going to do two seperate carvings, each one having its own mpc file, how do you know where to jog to position.
I will want them as close together as possible to minimize waste but I want to make sure they are far enough apart that I can cut them to the correct size afterward.
When you job to position to start the second carving is that the left end of the carving (as looking on designer) and is it the top or bottom of the carving (as looking in designer).
Just want to see what others have done or what they might suggest.
Thanks
I will want them as close together as possible to minimize waste but I want to make sure they are far enough apart that I can cut them to the correct size afterward.
When you job to position to start the second carving is that the left end of the carving (as looking on designer) and is it the top or bottom of the carving (as looking in designer).
Just want to see what others have done or what they might suggest.
Thanks