Help - Rotate?

[c6craig]

Hi All,

I am sure I missing something stupid here, but I can't get my brain to work right today..

I am trying to rotate these two groups 90 degrees so they both fit on one board. Anyone see what I am doing wrong? The option is greyed out..

It's just a cutpath with a little carving on it.

Thanks,
Craig

47499

[myshop1044]

Craig I had the same problem just a while back, check out the viedo by AskBud
Rotate a Connected Line Figure (http://www2.wcoil.com/~nharbison/CW-Rotate%20a%20Connected%20Line%20Figure.zip),
basicly all you do is create a pattern reinstall the pattern and then it will
allow you to rotate the pattern, check it out.

Perry
Myshop

[c6craig]

Thanks Perry! I'll check it out as soon as this current carve finishes! That way I can actually hear it, lol.

Thanks,
Craig