View Full Version : 1/16 in. straight cutting tool
mgsundgaard
08-25-2011, 04:25 PM
Has anyone ever used a 1/16" straight cutting bit? If so, where did you get the bit and what is the max. cutting depth per pass you would recommend. I have a need to cut repetitive parts from the same 1/8 to 1/4 thick board mounted in a sled and I want to reduce the waste to a minimum.
GrammaPam
08-25-2011, 04:36 PM
www.cw-parts.com (http://www.cw-parts.com) this would be the place to start looking. Ron will make a bit for you.
bergerud
08-25-2011, 05:45 PM
It was posted that the 1/16" cutting bit was out of stock a few days ago and so may still be. I believe the LOC is 1/4" .
Digitalwoodshop
08-25-2011, 07:45 PM
I have had success with the 1/16 end mill bit. I am still using the same one that I cut in half form a 6 inch long version used on my Star 912 rotary engraver years ago. It is the one on the top of the bit picture with no locking ring as I only use one bit when using it.
I use double stick tape to hold the sheet on a carrier board.
I was having trouble at first, one was a worn Y Bearing letting the teeth slip when under extreme pressure or resistance... Fixed the Bearing then the plastic was being pushed on the tape while I was cutting. I was using a rectangle with rounded corners and assigning the 1/16 inch end mill bit and setting a depth. NO Tabs as they would fracture the edge of the tag making a defect. The Tape worked better.
What I found was the cut path on the rectangle had 2 speeds.... 1st gear on the corners and 2nd gear on long areas. The 2nd gear was the problem... The Feed Rate was faster than my 1/16th end mill could clear a path and was pushing the plastic...
Lynn gave me a tip... IF I assigned the 1/4 inch bull nose to all the cut paths without tabs and setting the depth to the thickness of the material, 1/8 inch, and actually install the 1/16th bit.... It would cut in 1st gear only..
That worked.... That turned my business around as 2 sided tags were not available for purchase but 2 sided sheet stock was... This led me to my finest two sided Photo Accountability Tag.
I am still planning to make a vacuum sled... to eliminate the tape.
Good Luck in your adventure....
AL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.