devin07
01-16-2007, 09:00 PM
Hi,
Playing with the software while waiting for my machine and am having problems. I started with doming the wood. When I added a carve region, the carved region surface appeared to have an inverted dome surface. To get a flat bottomed surface I had to make this region a dome and then 'tweak' the height value to 100. I added a cross pattern to this surface but it isn't fully exposed (Cross2.mpc). If I change the height of the carved region to 0, then the cross is seen in its entirety (Cross3.mpc), but the surface returns to an inverted dome. Not sure what I'm doing wrong. I'd like a fully exposed cross on a flat bottom carved out region. Any thoughts?
Thanks,
Devin
Playing with the software while waiting for my machine and am having problems. I started with doming the wood. When I added a carve region, the carved region surface appeared to have an inverted dome surface. To get a flat bottomed surface I had to make this region a dome and then 'tweak' the height value to 100. I added a cross pattern to this surface but it isn't fully exposed (Cross2.mpc). If I change the height of the carved region to 0, then the cross is seen in its entirety (Cross3.mpc), but the surface returns to an inverted dome. Not sure what I'm doing wrong. I'd like a fully exposed cross on a flat bottom carved out region. Any thoughts?
Thanks,
Devin