newbie with questions

[Charles1964]

hey friends, wood for 25 years, new to all this, very exited to meet and have a blast

[dbfletcher]

Welcome to the forum! Did you already get your machine? New? Used? Revision? There a lots of ways to get tripped up as a newbie, so be sure to read as much as possible, and when in doubt, feel free to ask here. This is a great and very active forum and everyone is willing to help in any way possible.

[myshop1044]

Welcome Charles1964 to the forum, this is the best place to get help, advice or just good chat.
Where are you located in the big world?

Perry

[Charles1964]

winona mn. USA

[Charles1964]

awsome, got my machine after reading all the good bad and ugly, and sure enough my card reader didnt work, but after that i have had all good

[Charles1964]

am i still here?

[Charles1964]

new to forums to

[AskBud]

new to forums to
Go here, and review the first seven links.
AskBud
http://forum.carvewright.com/faq.php

[TerryT]

winona mn. USA

Charles, be sure to check the Start-U site for an instructor in your area and take the basic training class if you can swing it. It will give you a year or so jump on folks that haven't had the training.
Welcome to the forum

[jaroot]

It's a pretty steep learning curve, at least it was for me. But what a ride! These guys are great. They are always willing to help. This forum is what you paid for, the machine was just a bonus.

[skeeterman]

amen to that, this forum and members are what makes this machine run great.
steve

[woodchip]

Charles1964 WELCOME.
I'VE BEEN A NEWBIE FOR 2 YRS AND THE THINGS I KNOW:
1. ITS NOT A JOB, ITS AN ADVENTURE.
2LOT OF HARTBURN
3. LOTS OF FUN
4.LOT OF HARTBURN
5 .LOT OF GREAT PEOPLE WHO KNOW ALMOST EVERTHING
6.LOTS OF HARTBURN
7.ITS A GREAT MACHINE THAT MAKES SOME UNBIELEVABLE PRODUCTS.
8ONCE AGAIN. WELCOME AND ENJOY.
DON

[woodchip]

Charles, i forgot to tell you, the" tips and tricks " part will walk you thru some really cool stuff.
Don