PDA

View Full Version : 3 D Printing



Smoken D
07-14-2011, 08:42 AM
Very interresting, needs more progress but has gone very far. Kind of like a future replicator! Now before you watch the video, you need to know and notice that the wrench made from the 3d is NOT the same wrench shown as scanned. Also the reporter made a further info video called 3dresponse where he goes further into the story and explains. He also said he could tighten the nut, but when he pushed for really tight the 3d wrench broke. He was informed that there is another type glue making items stronger. But, as I said you should also watch the response film after the initial.

http://www.youtube.com/watch?v=ZboxMsSz5Aw

3d response

http://www.youtube.com/watch?v=cm2jvB3jhxM&feature=watch_response