PDA

View Full Version : Rectangle



rcdages
07-13-2011, 08:53 AM
Say, dose any one have a rectangle pattern that they would like to share?

Thank you.

Dan-Woodman
07-13-2011, 09:07 AM
rectangles are under "drawings" or under the icon picture of a retangle. Then you can use" carve region", select surface ,select texture,and have fun. also try "select puffing" for the raised panal look,
later Daniel

rcdages
07-13-2011, 09:13 AM
Dan,

What I am looking to do is to lay another ptn over top of part of the rectangle and do a cave and cut out, I believe I need a ptn for that, is that correct?

atauer
07-13-2011, 09:18 AM
You can design your rectangle, add a carve region to it, group it, and create your own pattern from it. Then you can edit however needed.

Dan-Woodman
07-13-2011, 09:25 AM
Robert
If I wasn't so "computor stupid" I would try to help. I'm sure someone will chime in and help us. Thats a nice thing about the forum , no one cares how much you know , there's always someone who will help.
later Daniel

TerryT
07-13-2011, 09:31 AM
Robert,
here is one I made with rounded edges. I use it a lot for signs.

rcdages
07-13-2011, 09:42 AM
Alex,

Thank you. I will try that when I get home tonight.

Let you know how that goes.

rcdages
07-13-2011, 09:44 AM
Hello Terry,

Thank you for the ptn.

when I get home tonight from work I'll download it.

I'll let you know how it goes.

TerryT
07-13-2011, 10:09 AM
You are very welcome my friend.

atauer
07-13-2011, 10:27 AM
No problem Robert. It should work for you. And, if it doesn't there are numerous other ways and a few good suggestions so far on how to achieve what you are wanting. I'm sure that others will chime in as well.

LittleRedWoodshop
07-13-2011, 11:14 AM
I think this is what you are trying to do ..... click on the image to download the MPC.

http://i44.servimg.com/u/f44/14/04/28/42/carvew14.jpg (http://www.mediafire.com/file/v0e6xqn0476xac1/for-robert.mpc)

rcdages
07-13-2011, 11:24 AM
Jason,

Thank you.

I will download tonight when I get home.

LittleRedWoodshop
07-13-2011, 11:25 AM
Is that close to what you were looking to do ???

rcdages
07-13-2011, 12:04 PM
Yes Sir,

That is what I am looking to do.