As anyone made a saw blade clock out of wood

[joe4800]

i like to make one but i dont know ware to start it looks like this 45590

[Digitalwoodshop]

I thought I saw a blade pattern somewhere.... Who was that pattern maker that was active in 2007.... Jance or something like that...

You could take a photo of one and bring it into designer as a pattern. Place it on a 15 inch wide board and using the line drawing and connect tools hand trace it... Using the lines that can be curved would be good...

Then make a cut path from the artwork... You make it on a 15 inch board so when you make it smaller the errors are less seen. Easier to trace.

But shortly someone will post a pattern.... They always do.... Great Place....

AL

[mtylerfl]

I thought I saw a blade pattern somewhere.... Who was that pattern maker that was active in 2007.... Jance or something like that...

AL

That is Jon Jantz (allcw.com) He was one of my early "forum mentors" and I miss him. I do not know what he's up to these days, but he was a great inspiration to me personally when I was first starting out with my CarveWright machine.

[bjbethke]

i like to make one but i dont know ware to start it looks like this 45590

I would make a saw pattern first, and then make a grid at 30 degrees to add the hour numbers. You could add a woodshop image??? I have several other Saw patterns, they are easy to make.

[Kenm810]

I'll toss one into the mix

[TerryT]

There are a couple of saw blade patterns on this page.

http://store.carvewright.com/pattern.php?vendor=terryt&page=8

[guido5286]

45621





Here is one someone else posted maybe it will help.

[SteveEJ]

Here is a Vector Clock. You can remove the rooster and numbers and have a cutout to work with.

4562445625