Maze MPC free for the asking

[myshop1044]

Feel free to use any or all of them. #4 in the Pictures does some strange things it may ask you filp the board and use a 90 deg bit. just ignore it and use a 1/4" bull nose and let it ride.

Have a good time

[Dan-Woodman]

Thanks for the mpc's myshop, did you add clear plastic to any of them with a hole for entry and exit?
later Daniel

[rfoster]

Thanks for the mpc's

Richard

[myshop1044]

Good Idea, never thought about that. I will have to see if it will work for me.
It might add to much weight since I will be using foam, maybe in some light pine it might would work.
Thanks

[b.sumner47]

Thanks for the maze mpc's Capt Barry

[Dan-Woodman]

MDF board would be good wood for this . It stays flat. You would just have to sand the fuzzies from the track edges , but the track would be clean. Hope you don't mind , I went over the mazes close up and connected several red dots that weren't touching and oriented the vertical and horizontal lines.
later Daniel

[myshop1044]

have fun , my 9 year old never notice, I was going to straigten them out before I sell them in the fall. He called and ask if I had any new mazes for him,
how can you turn him down on short notice.