View Full Version : "Flipping" a pattern?
keninar
06-14-2011, 08:24 AM
Is it possible to "flip" a pattern - essentially from "right-facing" to "left-facing."
Would like to use a purchased bass pattern from the depot - which faces right, but the end user would like it to face left.
Any thoughts?
Thanks!
-keninar
SteveEJ
06-14-2011, 08:51 AM
Select pattern then:
Layout->Flip & Rotate
bjbethke
06-14-2011, 08:53 AM
Is it possible to "flip" a pattern - essentially from "right-facing" to "left-facing."
Would like to use a purchased bass pattern from the depot - which faces right, but the end user would like it to face left.
Any thoughts?
Thanks!
-keninar
Yes you can flip or rotate, just select PTN and use these controls.
keninar
06-14-2011, 09:00 AM
Thanks guys! I swear I looked - and never saw the Flip and Rotate options.
So much to learn......so little time.!
Thanks again!
-ken
www.carvenow.com
06-15-2011, 12:58 AM
Another way to do this is: with the pattern selected, right click, a menu popup then scroll to "Lift & Rotate" then pick the lift options that you like.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.