Marzluf
01-14-2007, 07:47 AM
Sorry, no delivery from Sears yet, so I'm still playing with the designer.
My question is about text. I laid out a design last night and included some text. I gave the text a measurement from the bottom of the piece to align everything. Only problem was a lower case 'g'. Apparently, when there is a lower case letter than extends down below the normal writting line (bottom of all other letters), the software uses the lowest point as the bottomw of the word... Meaning, my word with a lower case 'g' was higher on the piece than the other words without...
Has anyone else seen this issue? Do you have to always reference the top of the workpiece for a measurement ??
Does any of this make sence how I'm describing it ?
My question is about text. I laid out a design last night and included some text. I gave the text a measurement from the bottom of the piece to align everything. Only problem was a lower case 'g'. Apparently, when there is a lower case letter than extends down below the normal writting line (bottom of all other letters), the software uses the lowest point as the bottomw of the word... Meaning, my word with a lower case 'g' was higher on the piece than the other words without...
Has anyone else seen this issue? Do you have to always reference the top of the workpiece for a measurement ??
Does any of this make sence how I'm describing it ?