JoeyZ
01-14-2007, 12:35 AM
Ok, I have a couple of problems and put them both in two seperate postings but will talk about both in each.
1. I can't register my software, my serial number has letters in it and my registration doesn't allow for letters. I tried just entering the numbers to no avail either.
2. I used the machine once for a small carving, and when I put in the board (yes I turned it off and gave the machine a break) it gave me a 281 RPM sensor fault and told me to press stop. I shut off the machine, hit it with compressed air and vaccuumed all the dust out. But when I turned it back on it gave me the same issue. The error is not in the book and not anywhere on this forum. Can someone tell me what this is? Or if there is a link to all the possible error messages and resolutions? It's hard to troubleshoot if you can't get all the info.
P.S. I tried calling the phone number several times before I got the machine and all I get is the run around answering machine to nothing.
1. I can't register my software, my serial number has letters in it and my registration doesn't allow for letters. I tried just entering the numbers to no avail either.
2. I used the machine once for a small carving, and when I put in the board (yes I turned it off and gave the machine a break) it gave me a 281 RPM sensor fault and told me to press stop. I shut off the machine, hit it with compressed air and vaccuumed all the dust out. But when I turned it back on it gave me the same issue. The error is not in the book and not anywhere on this forum. Can someone tell me what this is? Or if there is a link to all the possible error messages and resolutions? It's hard to troubleshoot if you can't get all the info.
P.S. I tried calling the phone number several times before I got the machine and all I get is the run around answering machine to nothing.