View Full Version : Query regarding Centerline Text and Quality
keninar
06-02-2011, 08:28 PM
Answer may be obvious - but never hurts to ask........
When using the Centerline function to engrave text, does the Quality setting have an effect on the cutting?
Have a project that will essentially entail only the Centerline text - and just wondering whether or not to go the Optimal route in this case.
Thanks in advance.
-keninar
AskBud
06-02-2011, 08:51 PM
Answer may be obvious - but never hurts to ask........
When using the Centerline function to engrave text, does the Quality setting have an effect on the cutting?
Have a project that will essentially entail only the Centerline text - and just wondering whether or not to go the Optimal route in this case.
Thanks in advance.
-keninar
My test load of a centerline test (no other carving) was 10 minutes on Normal. Increasing to Optimal raise the test to 10:59, which is much less of a jump that the same change for a Raster carve.
I would use Optimal, just on a chance that I might improve the quality.
AskBud
keninar
06-02-2011, 09:27 PM
Thanks, Bud. Thought the answer might be obvious.............but not THAT obvious!
Never thought about setting up a test carve and let the system answer my query.
Sigh. So much to learn. So many opportunities to confirm my ignorance.
Thanks again!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.