PDA

View Full Version : Things to buy while in Houston



gregsolano
05-05-2011, 03:09 PM
So I am going to the conference and I figure now is the time to buy all the little replacement things I will need and save on shipping.

I have a C machine which I bought used and it has a little over 100 hours on the motor. In the past I have seen posts about replacing brushes, certain bearings etc at certain hour intervals. What things should I purchase just to have on hand for the future while I am at the conference?

SteveEJ
05-05-2011, 04:06 PM
Sandpaper belts if you have not upgraded. I am not sure if the 'C' machine has the new rubber belts or not. Bearings, brushes, bits and any thing else you think might get worn out.

gregsolano
05-05-2011, 04:13 PM
I have the rubber belts and the brushes I was going to get, but which bearings?

lynnfrwd
05-05-2011, 05:13 PM
This is a GREAT THREAD! Mary will be operating the CW Store at the conference and this will help her know what inventory to have on hand.

We will have sale pricing and NO SHIPPING, but we do have to charge taxes..... :( .... :( ...I know!!!!...but it's the LAW!!!!...8.25%.

gregsolano
05-05-2011, 05:22 PM
This is a GREAT THREAD! Mary will be operating the CW Store at the conference and this will help her know what inventory to have on hand.

We will have sale pricing and NO SHIPPING, but we do have to charge taxes..... :( .... :( ...I know!!!!...but it's the LAW!!!!...8.25%.

Don't forget my commission on items sold from this thread! LOL

skeeterman
05-05-2011, 07:21 PM
Cut motor brushes, FFC cables, board sensor, board sensor cables are a few that I am wanting to buy while there
Steve

lynnfrwd
05-06-2011, 09:48 AM
Mary!!! You have some more things to add to your inventory list!!!

chebytrk
05-06-2011, 10:15 AM
Don't forget to lay out some Roller Belts. I need some.

lynnfrwd
05-06-2011, 10:34 AM
We will have both sandpaper & heavy duty.

fwharris
05-06-2011, 10:49 AM
Cutting and carving bits (1/16, 3/16, 1/8), motor brushes, replace cut motor (have one with cracked case @ flex shaft connection bringing bad one to change out), ribbon cables, X and Y belts..................