PDA

View Full Version : Cork Board Frame



Tim
01-12-2007, 12:03 AM
This is a frame I made for my son in a very quick project- only took 15 minutes in the software and about 12 minutes of carving time per side. The interior cork is just under 2' x 3', just the right size to hold a store-bought inexpensive bulletin board. The frame is only $4 worth of pine with golden oak stain and then polyurethane on it, but it jazzes up the board a lot...

BobHill
01-12-2007, 08:52 AM
Another good idea <g>

MacCarving
01-19-2007, 05:58 AM
Very nice. If the frame could fit into the CW, could you make it one solid piece?

BobHill
01-19-2007, 08:47 AM
Sure you could, Mac, but one side would be limited to less than 14½" and most would like the cork board a bit larger. besides, cutting the angles and edges for a proper fit etc. makes it a better challenge <g>.

Bob