Cork Board Frame

[Tim]

This is a frame I made for my son in a very quick project- only took 15 minutes in the software and about 12 minutes of carving time per side. The interior cork is just under 2' x 3', just the right size to hold a store-bought inexpensive bulletin board. The frame is only $4 worth of pine with golden oak stain and then polyurethane on it, but it jazzes up the board a lot...

[BobHill]

Another good idea <g>

[MacCarving]

Very nice. If the frame could fit into the CW, could you make it one solid piece?

[BobHill]

Sure you could, Mac, but one side would be limited to less than 14½" and most would like the cork board a bit larger. besides, cutting the angles and edges for a proper fit etc. makes it a better challenge <g>.

Bob