View Full Version : Wilderness Clock Silver Lining
dvel56
03-01-2011, 12:23 PM
While Carving a Wilderness Clock I lost power in my home about half way into the carve.
Instead of starting over with the carve I salvaged what was carved and created this project instead.
4267842679
Every cloud has a Silver Lining
Dvel56
Old Salt
03-01-2011, 12:33 PM
Looks like you planed it.
Some things do work out.
dvel56
03-01-2011, 01:21 PM
Adapt and Overcome! I had enough firewood
Very cool I love the antiquing of the wood! You when the power goes off, I have used the same board and started the project and it will air carve until it reaches the point it left off. Or in the designer you can put a region around the carved area just before where it left off and it will finish the project.
Ike
dvel56
03-01-2011, 01:40 PM
Thanks Ike
I did read on the forum about those two procedures. However I looked it up and read about it after I started the new board
Next time I will know but that might not let my imagination run WILD
Capt Bruce
03-01-2011, 04:21 PM
Nice save Dvel56,
I admire both your design adaptation and you paintjob. Nicely crafted in the end so well done Sir.
mtylerfl
03-01-2011, 04:56 PM
Good save alright! You invented a brand new project. Good Job!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.