Patterns

[toolbox]

Just started using my machine. Where do I find additional designs and patterns? The library is very limited.
Can different bits be used?

[Dan-Woodman]

Yes different bits can be used, NO BEARING BITS though.
There are companys out there that sell patterns you can download to designer and carve with your machine . Only problem I see with these is there $25.00 each.

[bamaman315]

what about a place on CW site where we could share patterns ?

[pkunk]

If you look through the posts especially in the Gallery, you'll find quite a few.

[toolbox]

Dan,
Does that include 1/8" bits? If so, where do I find an adapter?

[Dan-Woodman]

I'm not sure about 1/8" bits, the feed rate may be too fast for them.
I think sears carrys 1/4" bits that cut 1/16, 1/8 v- groove 90 and 60, etc.