Chino
02-06-2011, 04:11 PM
Hi Guys
Another thought. I took the cut motor out, took it apart and found no broken wires etc.
Since it's out and disconected from the CW I had a thought.
What is the voltage to the motor? I was thinking about putting power to it while it's out to see if it is alive. What do you all think?
Thanks Chino
Hi Guys
Today I got the new brushes for my cut motor. Put them in and back to normal. Talked to LHR and they said that the cut motor is 110V so I bumped it with 110V and it worked.
That was step 1. Step 2 was to put it all back together and see if it would carve. More later.
Just kidding. It works like a charm. Did a carve with no hic-ups.
Another thought. I took the cut motor out, took it apart and found no broken wires etc.
Since it's out and disconected from the CW I had a thought.
What is the voltage to the motor? I was thinking about putting power to it while it's out to see if it is alive. What do you all think?
Thanks Chino
Hi Guys
Today I got the new brushes for my cut motor. Put them in and back to normal. Talked to LHR and they said that the cut motor is 110V so I bumped it with 110V and it worked.
That was step 1. Step 2 was to put it all back together and see if it would carve. More later.
Just kidding. It works like a charm. Did a carve with no hic-ups.