Chino
02-05-2011, 12:55 PM
Hi Guys
Can some one give me a link to get a set of cut motor brushes. I've gone through the machine and checked wires, connectors, boards, switches and capacitor solder joints on the boards. The only thing I found were the brushes worn down to about 1/8" and a chip
out of one of them. I have a B machine with 335 hours on it. It goes through the whole sequence and wants to carve without the cut motor on. When it asks to install bit and you press enter the motor usually turns on for a second and stops which is normal and continues its sequence this dosen't happen now. Hence--check everything which I have.
Thanks Chino
Can some one give me a link to get a set of cut motor brushes. I've gone through the machine and checked wires, connectors, boards, switches and capacitor solder joints on the boards. The only thing I found were the brushes worn down to about 1/8" and a chip
out of one of them. I have a B machine with 335 hours on it. It goes through the whole sequence and wants to carve without the cut motor on. When it asks to install bit and you press enter the motor usually turns on for a second and stops which is normal and continues its sequence this dosen't happen now. Hence--check everything which I have.
Thanks Chino