lawrence
01-30-2011, 09:23 PM
Well folks, this one has me completely stumped.
I need to create "ditches" in the board that are 1/2 deep on one side and come up at a 45 degree angle to become level with the surface of the board... basically I need to be able to carve a 2 inch long right triangle trough into the wood.
Attached is a pic of what I'm talking about along with an MPC with my (head scratching) layout.
I'm really at a loss as to how to attack this problem-- I have at my disposal CorelDraw, Pattern Editor, Centerline, Conforming Vectors, and the DXF importer and have sleds that can hold the piece so that the edge is in a jig. I have all the standard bits at my disposal as well.
Could someone please explain to me how to create these "sloped troughs" in a piece of wood? I hope the answer is simple and that I'll feel stupid after this... Cleanliness of cut is important but not vital-- I can certainly (and probably will) clean up the carves with a sharp chisel.
Thanks a million in advance
Lawrence
I need to create "ditches" in the board that are 1/2 deep on one side and come up at a 45 degree angle to become level with the surface of the board... basically I need to be able to carve a 2 inch long right triangle trough into the wood.
Attached is a pic of what I'm talking about along with an MPC with my (head scratching) layout.
I'm really at a loss as to how to attack this problem-- I have at my disposal CorelDraw, Pattern Editor, Centerline, Conforming Vectors, and the DXF importer and have sleds that can hold the piece so that the edge is in a jig. I have all the standard bits at my disposal as well.
Could someone please explain to me how to create these "sloped troughs" in a piece of wood? I hope the answer is simple and that I'll feel stupid after this... Cleanliness of cut is important but not vital-- I can certainly (and probably will) clean up the carves with a sharp chisel.
Thanks a million in advance
Lawrence