Jrdarrah
01-29-2011, 03:07 PM
I just bougth dxf importer to allow me to draw my design in Turbocad. It worked fine to bring over the vectors. The figure outlined with a rounded corner rectangle that I'd like to apply a 1/8" bit with a -0.063 inset so that the bit is outside the line. This will be a piece of jewelry carved out of a 1/4" piece of wood fixed to a sled by carpet tape so I don't need to use a cut path, why by the way, is grayed out for a polyline. Is there any way to apply the negative inset sort of redoing the outline rectangle in thedrawing a half a diameter larger?