autobody
01-04-2007, 01:22 PM
I called CarveWright the other day to order a machine and was told to order it from Sears so I have. I also want to order the scan probe, but so far have not been able to get threw to CarveWright again, apparently Sears doesn't sell the accessories, anyway my question is:
If I jig a gunstock and scan it, can I add a carving to that scan in the software and then have it carve the gunstock so the depth of the carving matches the curves of the gunstock?
I carved this by hand with dremil type tools but it took me 18hours and I was hoping to use the machine (when I get it) to carve the other side.
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99644954.jpg
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99573428.jpg
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99621749.jpg
Thank you. ~Mike
If I jig a gunstock and scan it, can I add a carving to that scan in the software and then have it carve the gunstock so the depth of the carving matches the curves of the gunstock?
I carved this by hand with dremil type tools but it took me 18hours and I was hoping to use the machine (when I get it) to carve the other side.
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99644954.jpg
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99573428.jpg
http://www.PhotoShare.co.nz/PhotoShareGallery1/100503/107003/PICT99621749.jpg
Thank you. ~Mike