View Full Version : Material question for a newbie
fivsomwhere
01-03-2007, 10:38 PM
I am new to the carvewright and as I have been reading some of the forum I have noticed some people using some very thick and hard woods. My question is about graphite sheets. The thickest I would be cutting is .100" Would that be possible? Thanks to anyone willing to answer.
Greybeard
01-04-2007, 03:48 AM
By "graphite" sheets do you mean exactly that, or are you using carbon fibre sheets ?
Not familiar with the former, but carbon fibre is incredibly abrasive to the tool, in my experience, so you'll be doing a lot of bit changing. :(
John
Jeff_Birt
01-04-2007, 08:33 AM
And both a VERY conductive. I would say that conductive bits floating through the machine would not be good.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.