View Full Version : Chili pot
wasacop75
01-18-2011, 06:52 PM
I am trying to figure out how to get a smooth background on this carving.
So far, I am stumped. Oh, and the LOML would like the working to be carved in the pot and not the way i did it. Any help there?
will have to try and get the mpc smaller.
the LOML would like the wording (OSL Chili Cookoff ) somewhere on the pot.
I cannot get the mpc smaller than 1.34 meg.
Kenm810
01-18-2011, 08:18 PM
Something like this to work from ---- Maybe
Something like this to work from ---- Maybe
Well fine!!! Great job I am so glad you are a member! I don't care what they say about you! I know I have asked a million times, but here a million and one! What software do you use?
Ike
Kenm810
01-18-2011, 08:59 PM
Good Old -- Paint.Net -- 95% of the time.
cnsranch
01-19-2011, 09:22 AM
Ken - we sure could use a couple of lessons in paint from a guru..........
bjbethke
01-19-2011, 03:27 PM
I am trying to figure out how to get a smooth background on this carving.
So far, I am stumped. Oh, and the LOML would like the working to be carved in the pot and not the way i did it. Any help there?
will have to try and get the mpc smaller.
the LOML would like the wording (OSL Chili Cookoff ) somewhere on the pot.
I cannot get the mpc smaller than 1.34 meg.
Would this work?
wasacop75
01-20-2011, 09:00 PM
I want to thank everyone who reworked this for me. You people are the best, and i thank you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.