PDA

View Full Version : pattern question



ajk
01-18-2011, 09:06 AM
Do somobody can tell me what is going on with my software. Iam trying to do an onlay and the cut path is not complete. Also happens with the one that's come in the library. That's a question for the gurus. Thanks for the help.
Hilda

cnsranch
01-18-2011, 10:14 AM
Hilda - I THINK that the problem is that the cut paths that you're having problems with have a path that is actually smaller than the diameter of the cutting bit.

Standard cutting bit is 1/8" - if you select the 1/16" cutting bit during setting up the cut path, you'll see that more is cut out, but still not those areas that are less than 1/16" wide.

Make sense?

ajk
01-18-2011, 01:49 PM
I fix thepattern in pattern editor. but the center still. Ok when you select the outline pattern automatic come the cutpath . you change the bit after the cutpath. That's what I think.
Hilda