Rockler CNC?

[chebytrk]

Not sure if we've covered this before, but I heard that Rockler has a CNC that is supposed to give the CW a run? Anyone heard about this as far as the pros and cons for each one? Prices?

[Kenm810]

If you do a quick forum search for "Rockler Shark"
you'll find a few Threads with Posts going back to 2009
I've seen it, and was not very impressed

[myshop1044]

I have seen the Shark pro working and it 's ok, the big liminting factor btwn them and CW is the table size.
You can not make large project, cause it is liminted to the size of the table, and the CW can make long projects just with a couple extra roller stands.
Now if you want to spin about 4 to8 thousand $$$$ for a bigger table,that's ok too, even ShopBot is quite a bit of money for a large table.

Myshop