carve region

[papawbummie]

How can you make a carve region wide at the top like 1 inch wide than have it taper down to 1/2 wide at bottom of carve Thanks ,Bert

[Kenm810]

Quote: like 1 inch wide than have it taper down to 1/2 wide at bottom of carve

Here's few ideas to play-with or work from

[papawbummie]

Thanks for the design. I was wanting the one in the middle.Could you tell me how it was done.Thanks,Bert

[AskBud]

Thanks for the design. I was wanting the one in the middle.Could you tell me how it was done.Thanks,Bert

It was just a simple rectangle, the size you want, with a carve Region and a 1/4 feather applied.

Hint, It you reverse engineer the carve-list you can see how each was designed. The one on the right is the only one that used a pattern.
AskBud