cpd3020
01-02-2011, 04:59 PM
Hello, I purchased a great sign pack that Carvemore sells for around $30 for a bunch of signs. The first one I tried carving (which was 3D looking) keeps getting about 50% through the carve and I get Fatal Error 3 on it. I burnt through 3 pieces of wood so far and it keeps crashing on that design. If I run a totally different project, the other projects run just fine.
I read in some other posts that having the newest software installed (ver 1.177), some of the older patterns were having issues. I left a message with Carvemore but haven't received an answer. Anyone else having the same issue or same type of issue?
Thanks!
Shane
I read in some other posts that having the newest software installed (ver 1.177), some of the older patterns were having issues. I left a message with Carvemore but haven't received an answer. Anyone else having the same issue or same type of issue?
Thanks!
Shane