camp7
12-28-2006, 11:09 AM
I recently designed a simple cribbage board where all the 1/8” holes were made using the drill tool feature in the software. As I ran the project, the carver would momentarily stop the rotation of the bit as it moved to the next hole. I am concerned if all this stopping and starting will have a detrimental effect on the carving motor.
To those of you who have made cribbage boards; do you see the same reaction in your machine? Should I be concerned about this? Is there a way to over-ride this and have the rotation of the bit be on continuously for the entire project?
Have an enjoyable New Year,
Mike P
To those of you who have made cribbage boards; do you see the same reaction in your machine? Should I be concerned about this? Is there a way to over-ride this and have the rotation of the bit be on continuously for the entire project?
Have an enjoyable New Year,
Mike P