View Full Version : loade peice
eaglegolfj
12-26-2010, 04:05 PM
Trying to start a new carve piece. When i get to the part where it says load piece i do not get the enter to show up on the lcd display
mtylerfl
12-26-2010, 05:17 PM
Trying to start a new carve piece. When i get to the part where it says load piece i do not get the enter to show up on the lcd display
Hello,
A few things to check initially...
1) Make sure your board is a minimum of 1/2"-thick...less than that and the machine will continue to ask you to load piece
2) The shop cannot be too cold...the machine can "act up" if too chilly...55 degrees and over are what the machine likes
3) Check to see if you have a stuck pressure roller...blow out the switch with air while squeezing the roller up/down to free up the switch if needed
4) Could be a head pressure issue (too low). Check the pressure as outlined in your Owner's Manual if needed
Holler if none of that helps and you need more ideas.
eaglegolfj
01-22-2011, 08:54 AM
Ok thanks for the tips, sorry so long to reply
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.