cribbage board problems

[skeeterman]

I tried to carve both of these cribbage boards and i got an error 25 on both projects, even tried on different machine and got same error, any ideas,they were both found on the forum
steve

[fwharris]

At what point in the process do you get the error message and can you be more specific on what the error message said?

[skeeterman]

i got the error when trying to run the carving on the machine. prior to this i did two 1.5 hr projects that was on same card. when i tryed either of the cribbage board projects i got the error 25, went to diferent machine and tryed cribbage boards on it and got same error
steve

[skeeterman]

I took the cut path and the edge rout off of the larger mpc and reloaded on card, went to shop to see if i got same message , it went thru all the motions as if it was gonna carve and no error didnt have time to carve, as for the smaller board i dont know about it.
steve

[Digitalwoodshop]

If you have any Restraints on your locations where the numbers are YELLOW, change them to green and give it a try...

AL