bill.olney
11-28-2010, 04:56 PM
i am trying to carve my boat fleets logo onto the two hatches for my boat where the center of the image is centered on the seam of the hatches. when i carve out the upper hatch the image is up about one inch from the edge of the board. i have not done the lower hatch yet but i would expect the same result.
what am i doing wrong that the image is not on the edge of the board?
thanks, Bill
bill.olney@cox.net
what am i doing wrong that the image is not on the edge of the board?
thanks, Bill
bill.olney@cox.net