View Full Version : Cut motor
wasacop75
11-27-2010, 02:36 PM
I know it is probably out there, but can someone tell me why i can use the 1/16th carving bit but when i change to the 45 degree bit, the bit moves up and down, but the cut motor is not running. This is the second time on this carve. i dont know what is going on with this one.
Any help would be greatly appreciated.
wasacop75
11-27-2010, 03:04 PM
Ok, got that one to work, now the 1/8th in cutting bit wont work. took about 20 min for something to cool off till something started. And there is E006 error message.
Mine dose that too. Should I check the brushes? Not too sure how many hours.
CarverJerry
11-27-2010, 06:21 PM
It has been posted here that the magic number of hours on the cut motor is 250....then change the brushes.
CJ..........I'm getting really close myself, but I do have 2 sets ready and a 10 pack of bearings too.
Digitalwoodshop
11-27-2010, 07:08 PM
Also find the posts on the C1 Cap on the X Termination Board.
AL
wasacop75
11-27-2010, 08:14 PM
i can hear clicking like the motor wants to turn or it may be the bit moving across the board. i will take the time tomorrow and try to get to the bottom of this.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.