toymaker
12-17-2006, 08:07 PM
I am new here to the forum and it is my first post. First thing first...coodoes to the Carvewright team. The router is fantastic and I am having a ball doing things that have taken me forever (or at least seemed like it) :D .
My question is two fold....
1. From reading a few of the other post on engraving and carving small letters, it doesn't seem possible yet. However...is there any bit out there that would do the job? Like a Dremel engraving bit and i am sorry if this has already been answered.
2. For the two bits that were included with the CW...when time comes, is there a recommended fashion on sharpening the bits? Can they be sharpend using, sya, the Drill Doctor that is available on the market?
Thanks
My question is two fold....
1. From reading a few of the other post on engraving and carving small letters, it doesn't seem possible yet. However...is there any bit out there that would do the job? Like a Dremel engraving bit and i am sorry if this has already been answered.
2. For the two bits that were included with the CW...when time comes, is there a recommended fashion on sharpening the bits? Can they be sharpend using, sya, the Drill Doctor that is available on the market?
Thanks