PDA

View Full Version : Upgrading Software from Demo



wallyign
12-17-2006, 09:38 AM
I just received my CW today and I installed the full version of the software. Registered it and all. I did a small test carve and worked fine, just a bit louder than I expected.

In the demo version I had christmas patterns but they are missing in the full version. how can I copy them from the demo version to new version.

Wally

pkunk
12-17-2006, 09:44 AM
Do you have the Sears unit? The way I understand it, you must be only allowed the basic version of the software. The advanced version which has more features will be ready soon at additional cost.. The Carvewright guys will probably jump in at some point here and clarify your situation, ot you could call them for a more definative answer.