shotgun 6
11-13-2010, 02:27 PM
Need help with Z-axis stall. I am carving the victoriian Christmas ornimental and am on the second carve of a second set. The machine goes thru the measuring process with no problmem and asks for the cutting bit. After selected, the machine checks left and right properly, checks thickness and top of board on left side with no problem, then goes to the right side of board for thickness, touches twice for bottom, moves slightly right to plate, touches and gives Z-axis stall error message (0313). On the last touch (or third touch on the right of the board) , when I get the error message and the machine stops, the touch sounds like an on-off switch. I have run the Y-axis and Z-axis checks and get readings on both when I move the Z and Y trucks