PDA

View Full Version : Semi-stupid question


newcarver37
11-13-2010, 11:18 AM
Okay, here goes. I'm new to this machine and software and have yet to carve anything with it. My first project I wanted to do was an address plaque for my house. I can't seem to do anything with the software. I tried the tutorials on the CarveWright website and they seem confusing to me. Is there an easy way (short of paying for someone else's design) to do this project? Maybe a "CarveWright Software for Dummies" book. Thanks.
lhanner
11-13-2010, 11:52 AM
I am sending you a PM
Deolman
11-13-2010, 12:04 PM
Have you looked at the Tips & Trick?

http://www.carvewright.com/2010CWweb/tips.htm
Kenm810
11-13-2010, 12:19 PM
newcarver37,

I see you've been a member for a couple of years -- Welcome to the CW Forum

Like Deolman mentioned the Tips & Tricks are great place to start reading, loads of good info and how too's there.

Here's a little sample one you can play around with,
Try clicking on the Cut List to see how it's put together.