View Full Version : Non Member POM
jaroot
10-23-2010, 03:22 PM
Here is a little project that I'm working on. This could totally be done completely without the CW but hey it was fun to mess around with. Only uses one bit and a 1X8 48" long. Took about 45 mins of cut time for all three pieces.
mtylerfl
10-23-2010, 09:01 PM
That looks like a FUN project! Thanks for posting it!
jaroot
10-23-2010, 09:37 PM
Thanks Michael! I'll try to remember to post pics when I finish it.
And for those that say that the CW isn't accurate, the mortises and through tendons were cut with the CW and aside from easing the edges of the tendons to fit the round corners of the mortises, it slipped together nice and tight!
That looks like a FUN project! Thanks for posting it!
TerryT
10-23-2010, 10:20 PM
That is an interesting project, thanks.
robbrigg2
10-24-2010, 10:21 AM
Thanks Jaroot
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.